COR-4 Module

Features:

• Combination unit; all the functions of CWID  and COR in one 3 x 7 inch module.
• CMOS logic for low power consumption.
• Ideal for solar/battery powered repeaters; draws only 3½ mA on idle.
• ID's on initial key-up and every 9½ minutes thereafter when repeater is active.
• Courteous ID; waits until squelch drops.
• Circuitry is provided to interface a second receiver, either as an auxiliary input or to allow two repeaters to be cross-linked.
• Adjustable tone pitch and tail time.
• Factory programmed EPROM saves assembly time and allows longer messages.
• 1024 bit program space - enough for up to 100 characters .
• Simplifies wiring; many on-board traces replace harness wiring.
• Can operate in beacon mode for cw xmtrs.

PRICES:

COR-4 Module kit $99 (not avail wired/tested)

Shipping weight 1 lb.

Also, see:

Feedthrough Capacitors and Mtg Hardware

See what our customers say about these modules:

The 440 and 220 transmitter and receiver boards we purchased from you years ago are still in operation today and have been working at 100% the whole time. They are totally reliable and even working under some harsh weather conditions. The crystal heaters we installed in one location on the receiver boards keeps the frequency rock solid. The downtown repeater site has two UHF receivers, one 220 receiver, the main 220 transmitter exciter board plus 10 watt amp - and they all perform flawlessly all the time. Even after years of use to this day, they have never stopped working or drifted off frequency. We are also using ID boards, timers boards and so forth on two remote receiver sites - and they are all as accurate as the day we installed them over ten years ago. Good engineering designs - good going! Thanks. ... Tom Mogan, AA6IP; Sacramento, CA